CS System Filler 4+1 HS

CS System Filler 4+1 HS

Acrylic filler

Drscription
two-component high quality filler on the basis of resistant modified hydroxyl-acrylic resin of own production. It is high solid (HS) material, which ensures perfect filling properties. It fills scratches and porosity. Thanks to fine pouring its application provides very smooth and plain surface that minimizes subsequent sanding.

Alkyd, two-component acrylic and polyurethane enamels can be applied to the filler.

Suitable for applyin surface:

• old  coatings;
• steel;
• phosphatide washprimer;
• anticorrosive primer; 
• polyester putty.

Cautions:

• The minimum application temperature is +10°С. 
• Equipment and tools should not have traces of water. The relative humidity of the air is not higher than 80%.
• Thinner: "CS System Thinner 410".

Terms of use:

Stir all ingredients to a uniform consistency, respecting the mixing proportions. Apply with a gun layers of 30 - 40 microns with an exposure between layers of 8 - 10 minutes.

Primer – 100 Hardener – 33 Thinner – 20	22 – 26 secю at +20ºС В3 – 4	1,6 – 2,0 mm 3 – 4 bar 2 – 3 layers 100 – 120 micron	8 – 10 min at + 20ºС	4 h/+20ºС 45 min/+60ºС	Р 320 – Р 400	Р 600 – Р 1000